Habonim Catalog Interactive 2024 V04 15022024 - Catalog - Page 469
'Lock Pin' mounting kit
To enhance site safety by preventing unintentional remote operation of an automated valve,
Habonim provides a special lockable mounting kit. The '-LP' mounting kit consists of a special
bracket and coupler. A concentric hole drilled through the coupler and bracket allows a rigid
stainless steel pin to be slid through both elements, blocking the valve stem and actuator
pinion. The '-LP' mounting kit does not include the lock pin itself, only the preparation to fit the
lock pin as lock pins are normally part of maintenance toolbox.
Sample MK code description 'MK47-25-C35-LP'
Sample Lock pin kit codes:
• LOCK PIN KIT C15/C30
• LOCK PIN KIT C35/C45
• LOCK PIN KIT C60/C75
'IFM' mounting kit
When a small footprint automated valve is required, Habonim provides a special mounting
kit to allow easy installation of a barrel type proximity switch between the valve and actuator.
The '-IFM' mounting kit consist of a special bracket drilled to match the proximity switch
OD, and a unique coupler with two ferromagnetic pin targets connected to it. The targets
are aligned with the proximity switch unit so that when the actuator turns the valve to the
open or closed position, the proximity switch signals the valve’s position. This solution is an
ideal non-contact detection of metal targets in position sensing applications, combined with
smaller footprint allows for reduced space on the plant floor, but also minimizes the mounting
space for sensors used for position control.
Sample MK code description 'MK47-10/12-C25-IFM12'
IFM shows the proximity switch type, followed by a number (8, 12, 18 or 30 mm) which indicates
the outside diameter of the proximity switch cylinder.
'MOL' mounting kit
Manual operation of an automated valve is necessary during commissioning of a plant when
an energy source is not stable, in case of an emergency, when there is a power outage and the
valve must remain in the open or closed position, or due to an actuator malfunction. Normally
a declutchable gear would be used to integrate human intervention in an automated loop,
however for small size valves up to 1½" (DN40), Habonim recommends a cost effective
mounting kit that allows the operator to turn the valve manually. The 'MOL' mounting kit
consists of a unique coupler with milled flats, and a drilled hole in its center. The 'MOL' closed
box bracket is designed with an additional groove that allows a full quarter turn of a spanner.
The kit also includes a lock pin and 19 mm spanner chained to the bracket. To rotate the
pneumatically automated valve, disconnect the air pressure from the actuator. Hold the
coupler flats with the spanner, and turn the drive train to its counter position, slide the lock pin
all the way through the bracket and coupler to hold the valve and actuator in the new position.
Sample MK code description 'MK47-10/12-C25-MOL'
ACTUATION
469
