UL Catalog 2024-2025 - Flipbook - Page 46
FIXED LENGTH
SUBMERSIBLE
TURBINE PUMPS
FE PETRO® 2 Hp, 1½ Hp, and ¾ Hp fixed speed
submersible pumps are available with fixed lengths.
SPECIFICATIONS
General
Power Requirements
Check valve
2¾" diameter fluorocarbon seal constructed
on cast aluminum body and aluminum
backing washer
Incoming power
Fixed length, fixed speed models require
single-phase, 208-230 VAC, 60 Hz
incoming power
Pressure
relief valve
Available in four pressure relief settings,
integral to check valve. Standard model
relieves at 40 psi and resets above 35 psi
¾, 1½, and
2 Hp versions
Fixed length, fixed speed models are available
in ¾, 1½, and 2 Hp versions
Syphon
Venturi-type syphon primer supplied with
every submersible. Syphon check valve and
secondary syphon sold separately
Fixed length,
fixed speed
Fixed length, fixed speed models incorporate
a starting and running capacitor with internal
bleed resistor
Air eliminator
Every submersible includes a tank return
path with one-way check valve to provide
active air elimination
350 volt, 1
5 microfarad
A 370 Volt, 15 microfarad rated capacitor is
used with ⅓, ¾, and 1½ Hp fixed length, fixed
speed versions
370 volt,
40 microfarad
A 370 Volt, 40 microfarad rated
capacitor is used with 2Hp fixed
length, fixed speed versions
Single phase
SPGC-220 Guardian Series™ Single Phase
Smart Controller and STP-CBS single-phase
control boxes are available for fixed speed
pump control
Electrical
disconnect
Electrical yoke for positive contractor
disconnect during service
Approvals/
Certifications
- cULus listed
- Consult factory for applicable approvals
- Franklin Fueling Systems is an ISO
9001Certified Manufacturer
Liquid Compatibility
Pump Motor
Fixed speed
46
3450 rpm, multi-stage centrifugal type pump
motor with integral, automatic, thermal
overload protection
¾ Hp fixed speed
¾ Hp fixed speed models are available
as two-stage versions
1½ and 2 Hp
fixed speed
1½ and 2 Hp fixed speed models are available
in standard pressure (two-stage) versions and
high pressure (H option, three-stage) versions
Max. liquid
viscosity
70 SSU at 60° F (15° C)
Fixed length STP
Fixed length STP models are UL listed for fuel
mixtures containing up to 10% ethanol with
gasoline, and 20% MTBE, 20% ETBE or 17%
TAME with gasoline
STPAG/STPAP
(AG compatible)
STPAG/STPAP (AG compatible) models are UL
listed for fuel mixtures containing diesel fuel
with up to 20% Biodiesel, 100% Biodiesel, up
to 85% ethanol with gasoline, and 20% MTBE,
20% ETBE or 17% TAME with gasoline
All fixed
speed models
Fixed length models can also be used with
diesel fuels, fuel oils, kerosene, Avgas, and jet
fuels in a non-gelled pourable state
Wetted elastomers
All wetted elastomers are made of a high
grade, fluorocarbon compound
