UL Catalog 2024-2025 - Flipbook - Page 44
ORDERING INFORMATION
¾ Hp Fixed Speed Submersible Pump Ordering Guide
A typical turbine model designation has up to five components to
define the pump being supplied as follows:
STP XXXXX Y - A - B
STP = Basic Model Designation
XXXXX = Factory Installed Options (Model designations may
include one or more of the following characters in
alphabetical order).
AP = Advanced Protection with powder-coated, e-coated, and
stainless steel components, alcohol-gasoline compatible (up to
E85, up to B20, and B100) (Note standard models up to 10%
ethanol capable)
(B)
RISER
LENGTH
AG = Alcohol-gasoline compatible (up to E85, up to B20, and
B100) (Note standard models up to 10% ethanol capable)
F = Floating suction adapter (1½" NPT female adapter)
K = Intake filter screen (IFS, factory installed to PMA)
*R = Model R check valve (24 psi relief / 22 psi reset for PLLD)
Y = Pump Motor Horsepower Rating
(A)
MODEL
LENGTH
75 = ¾ Hp fixed speed
A = Model Length (see table)
VL1 = Variable length range #1.
VL2 = Variable length range #2.
VL3 = Variable length range #3.
(Note VL2 models fit 94% of all known installations)
B = Riser Pipe Length (see diagram)
Riser pipe length is expressed as two numeric characters that
indicate the total length of the riser in inches. Riser pipes are
available from 7" to 60" in 1" increments (additional charge
for risers 31" or longer).
Model Length (A)
*If not otherwise specified, all STP models are supplied with standard model
check valve (40 psi relief / 35 psi reset for MLD, TS-LS300, and TS-LS500).
STP
Horsepower
¾ Hp
44
Model Length Range
Model Length
Designation
57" – 86"
VL1
88" – 149"
VL2
120" – 212"
VL3
