UL Catalog 2024-2025 - Flipbook - Page 336
PROBE
INSTALLATION KITS
The digital inventory & leak detection probes come with
hardware that allows them to be installed at the bottom of the
tank. The install kits below provide a tight seal to either 2" or 4"
risers pipes preventing water intrusion and meeting regulatory
requirements. The 4" models also provide a quick release cap
for easy access to the probe for inspection or maintenance.
HIGHLIGHTS
ORDERING INFORMATION
• The TSP-K4AS/ASL install kits are for use with chemical or
other installations where it is desirable for the probe head to
be outside of the riser. It consists of a #316 SS 4" cap and
compression fitting that is installed on the probe shaft so
that only the floats and shaft are exposed to the tank
contents. Includes TSP-UVPK probe head protection kit.
Bottom Mount Kits
• The TSP-LPGK install kit is for use with pressurized LPG
tanks where the probe head will reside outside of the tank
opening. It consists of a special compression fitting,
designed to retain the contents of the pressurized tank, that
is installed on the probe shaft and then inserted into a
user-supplied cap with a ¾" NPT hole. Includes TSP-UVPK
probe head protection kit.
Model
TSP-C2A
TSP-C2B
TSP-C4A
TSP-C4B
Description
Mag probe install kit for 2" risers
Mag probe install kit for 2" risers with BSP threads
Mag probe install kit for 4" risers
Mag probe install kit for 4" risers with BSP thread
Other Kits
Model
TSP-K4AS
TSP-K4ASL
TSP-LPGK
Description
#316 stainless steel mag probe install kit for
4" riser pipes
#316 stainless steel install kit for probes
larger than 149"
LPG probe install kit, 149" maximum LL3
probe length
Note: TSP-LPGK install kit is not needed when locally supplied tank isolation
sleeve is utilized.
Cables
Model
600-0180
Description
Quick disconnect probe cable
Notes:
1. Cable is sold in 500' increments.
2. Contact technical service for more information on cable requirements and runs
greater than 500'.
Accessories
Model
TSP-DB1
TSP-DB10
TSP-DBTOOL
TSP-KW30
TSP-UVPK
Description
One direct burial splice connector kit
Pack of 10 direct burial splice connector kits
Epoxy dispensing tool
Pack of 30 3M™ splice connectors
Ultraviolet protection kit - protects probe
electronics when installed in AST applications
Notes:
1. Use the TSP-DB1 or TSP-DB10 for direct burial cable applications or when
weatherproof junction boxes are not used.
2. The DBTOOL is required to dispense the epoxy.
3. Each direct burial splice connector kit includes a receptacle, three splice
connectors, and epoxy for the dispensing tool.
Belden™ is a trademark of Belden Technologies, Inc.
3M™ is a trademark of 3M Company.
336
