EN Catalog 2021-22 - Catalog - Page 227
SPECIFICATIONS
Specifications
• 2 hp fixed speed models are available in variable length
and fixed length options.
•
•
Check valve: 70 mm diameter fluorocarbon seal constructed
on cast aluminium body and steel backing washer.
•
•
Pressure relief valve: available in four pressure relief
settings, integral to check valve. Standard model relieves
at 2.76 bar and resets above 2.41 bar.
200B models incorporate a starting and running capacitor,
with internal bleed resistor, rated 440 Volt,
40 microfarad.
•
STP-SCI single-phase smart controllers and STP-CBBS
single-phase control boxes are available for 200B control.
•
Syphon: venturi-type syphon primer supplied with every
submersible. Syphon check valve and secondary syphon
sold separately.
•
200C models require three-phase, 380-415 VAC, 50 Hz
incoming power.
•
Air eliminator: every submersible includes a tank return path
with one-way check valve to provide active air elimination.
•
STP-CBB three-phase magnetic starter available for
200C control.
•
Electrical disconnect: electrical yoke for positive contractor
disconnect during service.
Power Requirements
200B models require single-phase, 200-250 VAC, 50 Hz
incoming power.
Liquid Compatibility
• Max. liquid viscosity: 70 SSU at 60°F (15°C).
Pump Motor
• 2 hp fixed speed, 2875 rpm, multi-stage centrifugal type pump
motor with integral, automatic, thermal overload protection.
•
Available with MagShell® for 45% increased flow area
around motor.
•
Standard STP models are listed for fuel mixtures containing
up to 10% ethanol with gasoline, and 20% MTBE, 20%
ETBE or 17% TAME with gasoline.
•
STPAG (AG compatible) models are for fuel mixtures
containing diesel fuel with up to 20% biodiesel, 100%
biodiesel, up to 85% ethanol with gasoline and 20% MTBE,
20% ETBE or 17% TAME with gasoline.
•
2 hp fixed speed models can also be used for fuel mixtures
containing up to 5% biodiesel with diesel fuels, fuel oils,
kerosene, Avgas and jet fuels in a non-gelled pourable state.
•
All wetted elastomers are made of a high grade,
fluorocarbon compound.
Approvals/Certifications
• Consult factory for applicable approvals.
Quality Certification
• Franklin Fueling Systems is an ISO 9001 Certified Manufacturer.
2 hp Fixed Speed Turbine Performance Chart
(STP200C)
45
45
40
40
35
35
Total Head in Meters
50
30
25
20
30
25
20
15
15
10
10
5
5
0
0
50
100
150
200
250
300
350
Flow in Liters per Minute (LPM)
Note: Performance based on pumping solvent (0.78 specific gravity). Pressure
is taken at the manifold discharge outlet. Fixed Speed 2.00 HP was powered by
Single-Phase, 50 Hz, 250 Volt incoming supply.
400
SUBMERSIBLE
PUMPING SYSTEMS
Total Head in Meters
(STP200B)
50
0
0
450
50
500
100
150
200
250
300
350
400
Flow in Liters per Minute (LPM)
Note: Performance based on pumping solvent (0.78 specific gravity). Pressure
is taken at the manifold discharge outlet. Fixed Speed 2.00 HP was powered by
Three-Phase, 50 Hz, 415 Volt incoming supply.
227
450
