DAMPA Hook On - e-katalog - Catalog - Page 2
DAMPA® Hook-On
FIRE & SAFETY WITH SWING DOWN ACCESS
600 mm
Max 1650 mm
600 mm
B
C
B
C
A
A
This B-15/A-30 self supporting
Hook-On Ceiling System is designed specially for corridors.
Each full sized panel can swing down separately. This gives an unlimited access
to above services anywhere without disturbing the fire integrity of the ceiling.
No additional insulation is required. The ceiling joint ensures a tight, uniform “pencil” line
connection with all panels in flat alignment forming a distinctively plane and neutral ceiling area.
Widths of 300 or 600 mm and lengths up to 1600 mm are available. Read more here
Basic installations principles
This self supporting ceiling system consists of
only three basic components: Ceiling panels,
angle runners and cover profiles.
The simplicity of the system ensures a quick
and easy installation.
The 600 mm panels span up to 1600 mm and
are designed to swing down both ways and
separately.
Angle runners are identical at both sides of the
corridor. Cover profiles ensures the fire integrety
at the panel joints. Ceiling panels and cover
profiles are both supplied fully pre-insulated and
in pre-cut lengths to fit the width of the corridor.
No additional insulation is required.
DAMPA® Hook-On Panels will carry the weight
of smaller and lighter items such as smoke
detectors, spotlights etc.
Swing Function
Access to Services Above
Each full sized ceiling panel can swing down
separately along both sides of the corridor
walls. This gives an unlimited access to above
services anywhere in the corridor without disturbing the fire integrity of the ceiling.
General Ceiling Lay-out Principle
Ceiling panels are always to run crosswise to
the corridor.
Angle Runners No. 12 are installed along both
sides of the corridor.
Pre-insulated Cover Profiles No. 12 are inserted
above each ceiling joint.
Ceiling panels are normally installed progressively, starting at one end of the corridor.
Technical ceiling panels with integrated items
can be installed first and larger ceiling sections
in between left out to be installed later.
Cover profiles can also be left out in sections to
be installed later – or can easily be demounted
and re-instated if required.
2
Calculating Lengths
The lengths of the Hook-On Ceiling Panels are
determined by the internal width, bulkhead to
bulkhead minus 50 mm.
This will provide a closed shadow recess of
nominally 25 mm along the perimeter which
will absorb building tolerances.
The lengths of the Cover Profiles No. 12 are
determined by the internal width of the corridor,
bulkhead to bulkhead minus 20 mm.
Certificates and Approvals
DAMPA´s products are continuously tested
according to international requirements,
such as fire stability and integrity.
Certificates and approvals from leading
classification societies have been achieved.
Our products are in compliance with:
• Marine Equipment Directive
(Wheel Mark)
• IMO and SOLAS
• B-15 / A-30 approval
