SW Guest Book - Flipbook - Page 107
Troubleshooting Guide
within three seconds of each other and this will change the modes from EC
(economy mode), to SL (sleep mode) and finally to ST (standard mode) which is
what you want. Turn the heat to your desired temperature. Once you increase
the temperature on the hot tub to your desired settings, the display will go
back to the actual temperature of the water. This does not mean the hot tub
has reset. Your temperature is still set. DO NOT CONTINUE TO PRESS
BUTTONS. It will take about 15 minutes for the hot tub to increase one
degree. If this does not fix the problem an electrical outage may have caused
the breaker to flip. To fix, turn off the outdoor breaker and wait for 10 minutes
then turn the breaker back on. It should be in standard mode. If not follow the
instructions above to get the hot tub back into standard mode. The QR code
located on the refrigerator welcome letter will also show you how to get the
hot tub out of econ/sleep mode.
Jets not working: The mostly likely cause is that the jets are all closed. If too
many jets are closed it will cause the hot tub to malfunction. Check each jet
and make sure each is open about a ΒΌ turn only and then press jet button, do
not twist hard or the jet will break off
